Use your 500-Series Pocket-Hole Jig to create compact pocket holesThis unique Micro-Pocket™ Drill Guide Kit creates a 25% smaller pocket hole (15/16" long) that works great for smaller projects, thinner stock, and tighter repairs.
Micro-Pocket™ holes work great in virtually every application where you’d use standard pocket holes, and are especially good for 1/2" (12mm) thick material and narrow stock, down to 1" (25mm) wide. Because the bit removes less material, drill strokes are faster and easier.
Just insert the Micro-Pocket™ Drill Guide block into your Pocket-Hole Jig 520PRO, then use the Micro-Pocket™ drill bit to create the compact pocket holes.
For use with 500-Series Pocket-Hole Jigs. Compatible with Kreg® pan-head pocket-hole screws.
Compatibility:
- Kreg Pocket-Hole Jig 520PRO
- Kreg Micro-Pocket™ Drill Bit with Stop Collar & Hex Wrench
Important notes on working with Kreg Micro-Pocket Drill Guide:
Due to material variations (in particular metric vs imperial sheet goods) it is advisable to double-check all jig settings, stop collar position and screw length selection PRIOR to drilling into your workpiece. Use scrap pieces of the same material and perform test joins to verify a satisfactory Kreg Pocket-Hole join. Manual adjustments can then be made to ensure the drill point does not break through the bottom of the pocket-hole, and that the tip of the screw does not break out through your workpiece. This check is an important step when joining ½” to ½” or thinner material, where the margin for error is very small. Remember that you have three adjustments that can be made to get the perfect Kreg Pocket-Hole joint:
1. Drill bit stop collar position
2. Jig position on the workpiece (which may require thin packing material behind workpiece)
3. Screw length