UJK Bandsaw Buddy Setup Tool

• Designed and made in Axminster, UK
• Unique bandsaw blade aligning tool
• Checks the alignment of blade to the face of the fence
• Rare earth magnets hold it firmly on the blade, with a recess for teeth set for a true reading
• 250mm long makes it easy to spot any discrepancy and adjust accordingly
• Scale on the tip helps set fence for cutting veneers or thin boards
• Holes for drawing circles in 25mm steps from 75 to 400mm
• Accurately machined from anodised aluminium, doubles as a small straight edge

UJK's Bandsaw Buddy is a unique bandsaw blade aligning tool, Made in Axminster UK!

The Bandsaw Buddy is a handy tool that allows you to check the alignment of the bandsaw blade to the face of the fence. Truing the fence to a blade can be a tricky job. The Bandsaw Buddy simplifies this - two rare earth magnets hold the tool firmly on the blade, with an additional recess for the set of the teeth, providing a true reading off the blade. At 250mm long, it is an easy task to then spot any discrepancy in the fence alignment and make necessary adjustments. Aligning your fence to your blade allows for even and consistent cuts.

The handy magnets will also keep it safely stored on the bandsaw’s frame when not in use, while a scale on the tip helps set the bandsaw fence width for cutting veneers or thin boards. Holes along the Buddy’s length at 12.5mm intervals allow you to draw arcs or circles in 25mm steps from 75mm to 400mm, a useful feature for marking curves or when cutting bowl blanks.

Accurately machined from anodised aluminium, it also makes a handy straight edge.

An all-round useful tool, specifically for bandsaw use! Hence the name...